Telwin MASTERCHARGE 740/2 Manuel D'instructions page 4

1. SAFETY INSTRUCTIONS
• Hazardous voltages are present on the device and the
power lines which could cause death.
• The connections compartment should only be opened
by qualified staff.
• The charging station must be installed by a specialist
technician who is responsible for compliance with
standards and provisions in force.
• Use the device exclusively for applications compliant
with its intended use.
• Check insulation of the cables is not worn.
• Do not use adaptors or extensions of the charging
cable
• Maintenance interventions must only be carried out in
authorised centres.
• The device must be supervised when used with children
present.
• Damage caused to the product can make it unsafe. The
product must be electrically insulated and must NOT
be used until the necessary corrective measures are
implemented.
ADDITIONAL PRECAUTIONS
During the charging
procedure, the cable
must not be strained.
The charging cable
must not be bent or
twisted.
Do not drive over the
charging cable or
connector with the
vehicle.
The charging cable
must be wound and
repositioned in a
compact manner.
- 4 -
2. TECHNICAL SPECIFICATIONS
The main data on use and performance of the charging station
is summarised on the rating plate and has the following
meaning:
Fig. A
1. Name of model.
2. Mains connection: voltage, frequency, current intensity.
3. Protection rating of the casing.
4. Working temperature.
5. Reference standard.
6. Manufacturer's name and address.
7. Serial number to identify the charging station (essential for
technical assistance, spare part requests, tracing of product
origin).
8. CE symbol.
9. Indication: read the instructions.
10. Disposal instruction.
NB: The rating plate shown is an example to explain the
meanings of the symbols and figures; the exact technical
specifications for the charging station should be taken directly
from the rating plate on the device. Further technical details
are found in the APPENDIX.
3. DESCRIPTION
This charging station is an ideal solution to create a safe
charging point for your electric car.
Main features:
• Provided completely assembled and tested for simple and
fast wall installation.
• Integrated vehicle side cable (5 metres), with the Type 2
connector.
• Continuous control of the charging process to guarantee
user and vehicle safety.
3.1 Control and connection devices
Fig. B
1. Emergency button: in an emergency situation, press the
switch to interrupt vehicle charging. To reset the switch,
turn it clockwise until the actuator lifts.
2. Card sliding area: on passing the card, the process starts (or
stops) of vehicle charging.
3. Led bar with 3 different colours:
a. Green: vehicle disconnected.
b. Blue: vehicle connected.
c. Red: Alarm.
4. Power cable input.
5. Charging cable.
6. Type 2 charging connector (IEC 62196-2).
3.2 Protection devices
1. Over and under voltage.
2. Overcurrent.
3. Short circuit.
4. Emergency button intervention.
5. Plug connection anomalies.
6. Power relay fault
7. Residual DC current towards earth detected.
3.3 OPTIONAL ACCESSORIES
• Dynamic balancing kit of the load
4. INSTALLATION
The installation operations can only be carried out by
adequately qualified people and who have read and
understood the instruction manual.