resideo Honeywell Home R200C-N1 Guide D'installation Et D'utilisation page 8

10. Health effects of carbon monoxide
~ - 00100 ppm : Slight headache, flushing of skin (indefinite exposure).
200 - 00300 ppm : Headache (5 – 6 hour exposure)
400 - 00600 ppm : Severe headache, weakness, dizziness, nausea, vomiting (4 – 5 hour exposure)
1100 - 01500 ppm : Increased pulse and breathing rate, syncope (fainting), coma, intermittent
seizures (4 – 5 hour exposure)
5000 - 10000 ppm : Weak pulse, depressed respiration / respiratory failure, death (1 – 2 minutes
exposure)
 This CO alarm may not prevent the chronic effects of carbon monoxide exposure and will not fully
safeguard individuals at special risk.
11. Wireless functions
(see page 4)
Interconnect your alarms
a) Place the interconnected CO alarms as close as possible, not further than 5 meters apart.
b) Choose one CO alarm as Master. Press 3 times its TEST/SILENCE button. The green light will turn on.
c) Choose another CO alarm as Slave. Press 3 times its TEST/SILENCE button. The green light will turn
on.
d) Wait for a few seconds until the green light starts flashing, indicating successful network pairing.
e) Repeat step b) for connecting more interconnected CO alarms.
NOTE: always use the same Master alarm for connecting additional Resideo interconnected smoke, heat or
carbon monoxide (CO) alarms, now and in future. Write down which interconnected alarm in your home is
the Master.
After all the CO alarms are connected, the master CO alarm will automatically exit the connect mode in 5
minutes. You can also press the TEST/SILENCE button to exit manually.
Test your interconnection
Hold down the test/silence button.
The master CO alarm will beep continuously with the red "ALARM" text indicator flashing.
Other interconnected CO alarms will receive the signal after few seconds, and they will
beep continuously with the red "ALARM" flashing.
-8-