EINHELL 11054 Mode D'emploi page 10

Anleitung_RT_AG_115_SPK1:_
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety information
Please refer to the booklet included in delivery for the
safety instructions.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1)
1. Spindle lock
2. ON/OFF switch
3. Additional handle
4. Guard
5. Flange nut wrench
3. Proper use
The angle grinder is designed for the cutting and
rough grinding of metal and masonry using the
appropriate cutting disk or rough grinding disk.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
10
15.09.2008 8:48 Uhr Seite 10
4. Technical data
Mains voltage:
Power input:
Idling speed:
Max. wheel diameter:
Mounting spindle thread:
Protection class:
L sound pressure level:
pA
L sound power level:
WA
Vibration a
Weight:
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
5.1 Fitting the additional handle (Fig. 2)
The angle grinder must not be used without the
additional handle (3).
The additional handle can be secured in any of
three positions (A, B, C).
Tool side
Left (position A / as
shown)
Right (position B)
Top (position C)
5.2 Setting the guard (Fig. 3)
Switch off the tool. Pull the power plug.
Adjust the guard (4) to protect your hands so that
the material being ground is directed away from
your body.
The position of the guard (4) can be adjusted to
suit the working conditions; turn the cover (4) into
the required position. The locking lug (a) on the
guard (4) must engage in the appropriate
position (b).
Ensure that the guard (4) correctly covers the
gear wheel casing.
Ensure that the guard (4) is securely engaged in
the correct position (b).
230 V ~ 50 Hz
11.000 rpm
:
hv
Suitable for
Right-handed users
Left-handed users
Using cutting wheels
600 W
115 mm
M14
II / ®
87 dB
103 dB
≤ 2.5 m/s 2
1.8 kg