Publicité
Les langues disponibles
Les langues disponibles
any stubborn deposits using a cleaning
brush. Any discolouration of the bowl
will not affect its performance.
Bowl Drive Shaft/
Slow Cook Plug
Fitting the Bowl Drive Shaft/Slow Cook
Plug
Refer to Illustrations
1
Ensure the seal is fitted to the drive
shaft or slow cook plug before fitting
to the bowl.
2
Fit the drive shaft or slow cook plug
inside the bowl and align with the
drive shaft nut on the underside of the
bowl.
3
Lock the drive shaft nut by turning
clockwise until aligns with the
Removal of Bowl Drive Shaft/Slow Cook
Plug
Refer to Illustrations
1 Unlock the drive shaft nut on the
underside of the bowl by turning in an
anti-clockwise direction.
2 Then lift out the drive shaft or slow
cook plug.
3 Remove and wash the sealing ring.
4 Brush the bowl drive assembly or slow
cook plug clean with hot soapy water,
then rinse thoroughly under the tap.
5 Ensure the seal is refitted to the drive
shaft or slow cook plug correctly before
refitting to the bowl.
Q1
–
Q3
.
R1
R3
–
Lid
Always dismantle the lid before
cleaning:
1 Remove the filler cap.
2 Push the lid inner section out.
3 Remove the seal from the lid inner
section.
After washing, fit the seal back on to
the outer lid section with the thicker
edge uppermost and reverse the above
procedure.
Note: leaking from the lid will occur if the
seal is not fitted correctly or damaged.
Direct Prep
Dismantle the attachment fully before
cleaning.
For easier cleaning, always wash the
parts immediately after use.
Handle the cutting discs with care –
they are extremely sharp.
To remove the lid from the base,
hold by the feed tube and turn in an
anticlockwise direction. Then lift off.
Tower: do not immerse in water. If
the tower is accidentally immersed in
water, ensure that all the water has
drained out before reassembling the
attachment.
Steamer Tray/Condensation Trap/
Weighing Bowl
Wash the parts, then dry thoroughly.
23
Publicité
