arjo MAA2070M Mode D'emploi page 11

WARNING
To avoid injury to the patient, pay close
attention when lowering or adjusting the
spreader bar.
Move the lift/spreader bar closer to the patient's
Slightly lift the patient to create tension in the
WARNING
To avoid the patient from falling, make sure
that the sling attachments are attached
securely before and during the lifting
process.
Removing the Sling
In Bed (13 steps)
Apply bed brakes and adjust the height of the bed
WARNING
To avoid injury to the patient, pay close
attention when lowering or adjusting the
spreader bar.
weight of the patient is taken up by the receiving
(See Fig. 5)
(See Fig. 17)
If using an In Situ sling and leaving it under the
patient, make sure to place the sling straps along
Fig. 15
(See Fig. 4)
(See Fig. 20)
Fig. 16
Make sure that:
• All clips are securely attached
•
•
If an adjustment is needed, lower the patient and
make sure that the weight of the patient is taken up
Make sure that:
•
• One caregiver pays attention to the patient's
head and the other caregiver holds up the
patient's feet to prevent them from hitting the
(See Fig. 19)
Release the brakes on the lift and bring the lift legs
WARNING
To avoid injury during log roll, make sure
there is another caregiver present and/or
use the side rails on the opposite side of
the bed.
rolling is not possible, use an Arjo sliding sheet/
sheet/tube IFU.
(See Fig. 21)
Log roll the patient to the other side and remove
Make sure the patient is in a comfortable and
Fig. 17
11
Sliding
Fig. 18
EN