Beko BHCA63741BHSI Mode D'emploi page 18

5
Installation of appliance
Ø4,8x50mm
(Figure 9)
Hold the cooker hood by its body and place it on
the mounting screws on the wall and tighten the
screws (Figure 9).
Secure the cooker hood with two 5.5x60 screws to
the wall through the mounting hole on the interior
of the appliance (Figure 9).
5.4 Connecting to flue
(Figure 10)
1. Flap pin socket
2. Flap pin
Insert the plastic pin (Figure 10/area no. 2) on
the pin socket on the motor exhaust (Figure 10/
area no.1). Then bend the flap lightly to insert the
other pin on the flap and insert the other pin to its
socket (Figure 10).
18 / EN
If you are going to use the Ø 120/150 mm plastic
flue adapter, connect one end of the pipe to this
adapter, if you are not going to use it, to the direct
output on the product. Connect the other end of
the pipe to your flue. Check that these two con-
nections are tight enough so they will not come out
when the appliance runs on full power. Ensure that
the flaps inside the flue work when tightened with
clamp. Connect the flue connection duct outside
the adapter (Figure 11/a). If the connection duct
is fitted inside the adapter, suction of air shall not
occur as the flue flap that prevents the return of
air will remain closed (Figure 11/b). The length
of the pipe connection as well as the number of
elbows must be as minimum as possible.
A : Flue exit pipe
B : Flue clamps
C : Plastic flue
The valves are closed then the appliance is not
operating and prevent possible outside odour and
dust from entering inside.
Suitable
(Figure 11)
5.5 Installation of the hood to the
flue
Make the electrical connection of your hood before
starting the installation of the flue. Slip the outer
flue around the body. Screw the flue from two lo-
wer corners to the flue fastening plates available
on the motor cabin. (Figure 12).
Cooker Hood / User Manual
Not suitable