Beko BHCA63741BHSI Mode D'emploi page 17

5
Installation of appliance
10. 5.5x60 wall mount screw
11. 3.9x22 flue connection plate screw
12. 3.5x9.5 Flue connection screw
13. Ø120mm flue adapter
14. Ø120mm flue flap
15. Air baffle
The information required to make the location sui-
table for the installation of the hood is given below.
5.3 Wall mounting
• Wall must be flat, straight and have the sufficient
bearing capacity.
• Depth of drilling holes must comply with the
length of bolts.
• The bolts and dowels provided are suitable for
brick walls. For other construction material (e.g.
drywall, plate, porous concrete), suitable fixing
dowels and nuts shall be used.
(Figure 7)
CAUTION: Before drilling, ensure
A
that there are no power, gas or wa-
ter pipes in the close proximity of the
drilling locations.
Draw a mid location line from the ceiling perpendi-
cular to the lower edge of the hood.
Paste the installing template provided within the
accessories on the surface where the hood is to
Cooker Hood / User Manual
be mounted. In doing this operation, observe the
mounting height of the hood (Figure 6).
There is a tab in the middle of the flue connection
plate. Place the middle point of this tab on the line
that is drawn perpendicular to the wall. In doing
this operation, adjust the hood according to the
maximum height (Figure 1). Mark the holes whe-
re the flue connection plate will be mounted with
the help of a pen (Figure 7/a).
Drill the marked points with Ø6mm drill and in-
sert 2 plastic dowels in the drilled holes (Figure
7/a). Fix the flue connection plate to the wall with
3,9x22 screws (Figure 7/a).
To assemble the hood body, you can use the A,
B, C, D Ø10 mm drill on the assembly template,
and insert Ø10 mm plastic dowels at these points.
(Figure 7/b).
2 piece 5.5x60 suspension screw with a clearance
of 5 mm between the screw head and the wall
(Figure 7/b).
(Figure 8)
1. Hanger plate
Ø10mm
2. Hanging plate connection screw
Ø5,5x60
In order to install your hood to the wall, loosen the
screws on the hanger plates mounted on the mo-
tor cabin and pull them up, and then fasten again
(Figure 8/A).
Turn on the suction glass of the hood and remove
the aluminum oil filter (Figure 4).
17 / EN