Beko BHCA63741BHSI Mode D'emploi page 15

4
Cleaning and maintenance
The device should be cleaned and maintained
regularly. Failure to keep the device clean will
adversely affect the service life of the device. For
cleaning and maintenance, follow the instructions
stated in the manual.
C
Before cleaning and maintenance,
unplug the product or turn off the
switch.
Non-compliance with the provisions
associated with the cleaning of the
device and replacement of the filters
may result in a risk of fire. Therefore,
it is recommended to follow the gui-
delines stated here. The manufactu-
rer is not responsible for the engine
damages or fires originating from the
improper use.
Clean using only a cloth dampened with a neutral
liquid detergent. Do not use abrasive products or
alcohol.
4.1 Cleaning of the aluminium oil
filter
This filter retains the oil particles in the air.
Aluminium oil filters may change colour as they
are washed; this is normal and does not require
replacing your aluminium oil filters.
(Figure 4)
Cooker Hood / User Manual
• Push the aluminium oil filter lock forward.
• Then pull it slightly down and pull it out (Figure
4). Otherwise, you can bend the filter. Wash and
rinse aluminium oil filters with liquid detergent
and replace aluminium oil filters to their sockets
by by carrying out the steps specified above in
reverse order. This filter retains the oil particles
in the air.
C
You may wash your aluminium oil
filters in the dishwasher.
A
CAUTION: In case of normal use,
clean your filter once in a month.
4.2 Replacement of carbon filters
Odour removing filters contain charcoal. Grease
filters must be installed in the product, regardless
of whether or not charcoal filters are used.
(Figure 5)
• Remove the aluminium oil filter (Figure 4).
• To remove the carbon filter, remove the carbon
filter from its housing by rotating it counter-
clockwise from the tab (Figure 5).
• Install the new carbon filter.
• Install the aluminium oil filter.
15 / EN