Kohler K-1913 Instructions D'installation page 30

Blue
Screw
Red
Screw
Adjust roller
and mounting
bracket contact.
Pulley
Assembly
1
Tighten
nut.
Adjust the bumper pads.
17. Adjust the Bath Door
All Installations
Check and Adjust the Door Movement
Move the bath door up and down several times with one finger. Check for uneven movement,
rubbing, or shaking.
If the door shimmies or racks, adjust one or both of the mounting brackets inward using the blue
screws and slots, until they are snug against the rollers.
If the door shimmies more when it is fully lowered, adjust the bottom of each mounting bracket
inward using the top screw as a pivot point.
If the door shimmies more when it is fully raised, adjust the top of each mounting bracket inward
using the bottom screw as a pivot point.
NOTE: When properly adjusted the door should move up and down using one finger.
1128532-2-G
All manuals and user guides at all-guides.com
Mounting Bracket
Lift and lower door several
times with one finger to
establish smooth travel.
Limit Switch
2
Adjust the limit switches.
Bumper
Latch Pin
(Centered)
Strike
Plate
Screw
30
Proper Bumper Adjustment
Improper Adjustment
(Blue Boot is not Visible)
3 Blue
Boot
Proper Adjustment
(Blue Boot is Visible)
Kohler Co.