Kohler K-1913 Instructions D'installation page 14

Remove Pulley Assemblies
Limit Switch
Red Screw
Pulley
Assembly
6. Remove the Pulley Assemblies and Mounting Brackets
Installations Requiring Disassembly Only
Disassembly Checkpoint #2
The steps below may not be necessary. Make sure removing the pulley assemblies,
mounting brackets, and/or receptor tray is required. The bath can usually be moved into
place after the door is removed.
If the bath can be moved into place without further disassembly, go directly to the
"Position the Bath" section.
IMPORTANT! Save and organize all screws and hardware. All parts will be reused.
Remove the Pulley Assemblies
Pull the limit switch wires at the top of each pulley through the opening in the bath until the
connector appears, then disconnect them.
Remove the four red screws from the drain side of the bath. Take care not to strip the screw heads.
Remove the pulley assembly from the drain side of the bath.
Remove the four red screws from the other side of the bath. Take care not to strip the screw heads.
Remove the pulley assembly from the other side of the bath.
Remove the Mounting Bracket
Remove the four blue screws from the drain side of the bath. Take care not to strip the screw heads.
Remove the mounting bracket from the drain side of the bath.
1128532-2-G
All manuals and user guides at all-guides.com
Remove Mounting Brackets
Connector
14
Blue
Screw
Mounting
Brackets
Kohler Co.