Kohler K-1913 Instructions D'installation page 29

Water Inlet
Nut
and O-Ring
Drain Valve
Attach the drain.
Connect to controller, J2.
16. Connect the Components
All Installations
NOTE: Depending upon disassembly, some or all of these components may still be connected.
Confirm the O-ring is in place and connect the water inlet to the drain valve by tightening the nut.
Connect the drain valve power at controller J2. Do not plug the drain valve power cord into a
receptacle other than J2.
Connect the level sensing wires at controller J3.
Connect the limit switches at controller J4.
NOTE: Port J5 should remain unused.
Connect the door power at controllers J6 and J7.
Kohler Co.
All manuals and user guides at all-guides.com
Controller
29
J1 - Power Cord to Wall Outlet
J2 - Power Cord to Drain Valve
J3 - Connection for Level Sensing Probes
J4 - Connection for Limit Switch Wires
J5 - Open
(Alternate for Level Sensing Probes)
J6 / J7 -
Power Cord Connection to Door
1128532-2-G