Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Plug cord into wall receptacle. Your humidifier is now ready for use. The humidifier
should be placed at least FOUR inches away from any walls and away from heat
registers. Unrestricted airflow into the unit will result in the best efficiency and
performance.
NOTE: This unit has a humidistat located on the cord that senses the humidity level
around the immediate area of the humidifier. It turns the fan on when the relative
humidity in your home is below the humidistat setting and will turn the fan off when
the relative humidity reaches the humidistat setting.
CONTROL PANEL
This unit is controlled by two buttons.
To Turn On and Off
Press and hold the portion of the button with
the fan icon to turn the unit on and off.
Fan Speed
After unit is on, press the same portion of
the button to adust the speed. Fan speeds
proceed from high to medium to low.
Humidity Setting
Use the portion of the button with the droplet icon to adjust
humidity. Humidity settings will increase in 5% increments to 65%.
Once the 65% setting is selected the humidifier will run
continuously.
NOTE: When excessive condensation exists, a lower speed setting is
recommended.
Display
The digital panel displays fan speed (F1 - F3) and humidity levels
as they are adjusted. Once set, the room humidity will display.
OTHER INDICATIONS
CAUTION: Disconnect power before cleaning or servicing
unit. Keep grille dry at all times.
REFILL INDICATION
1) When the unit is out of water, the display flashes F, the blue
light illuminates and the motor automatically shuts off.
2) Refill unit according to the instructions in the WATER FILL section.
DRYOUT FEATURE
If not refilled, the unit will enter into Auto Dry Out mode. The fan will
run on the lowest speed for an hour, drying out the wick to reduce
mildew growth.
This humidifier has a check filter reminder timed to appear after 720
hours of operation. When the Check Filter (CF) message is displayed, disconnect the
power cord and check the condition of the filter. The CF function will reset after the unit is
plugged back in.
6
Publicité
