Teac AD-500 Manuel Du Propriétaire page 5

Voltage Conversion
(For general export models)
Be sure to remove the power cord from the
AC outlet before repositioning the voltage
converter switch.
1. Locate the voltage selector on the rear
panel.
2. Using a flat-bladed screwdriver, set to
the appropriate 230 V or 120 V position
according to your area.
IMPORTANT (for U.K. Customers)
DO NOT cut off the mains plug from this
equipment. If the plug fitted is not
suitable for the power points in your
home or the cable is too short to reach
a power point, then obtain an
appropriate safety approved extension
lead or consult your dealer.
If nonetheless the mains plug is cut off,
remove the fuse and dispose of the plug
immediately, to avoid a possible shock
hazard by inadvertent connection to the
mains supply.
If this product is not provided with a
mains plug, or one has to be fitted, then
follow the instructions given below:
IMPORTANT. DO NOT make any
connection to the larger terminal which
is marked with the letter E or by the
safety earth symbol ç or coloured
GREEN or GREEN-and-YELLOW.
The wires in the mains lead on this
product are coloured in accordance
with the following code:
BLUE: NEUTRAL
BROWN: LIVE
As these colours may not correspond
with the coloured markings identifying
the terminals in your plug proceed as
follows:
The wire which is coloured BLUE must
be connected to the terminal which is
marked with the letter N or coloured
BLACK.
The wire which is coloured BROWN
must be connected to the terminal
which is marked with the letter L or
coloured RED.
When replacing the fuse only a
correctly rated approved type should
be used and be sure to re-fit the fuse
cover.
IF IN DOUBT — CONSULT A
COMPETENT ELECTRICIAN.
Connections
O Before connection, turn off all
components and pay special attention
to left (L) and right (R) channel
indications.
O Read the owner's manual of each
component you intend to use with this
unit.
∑ Signal cords
LINE IN / OUT terminals
Connect the LINE IN terminals to the TAPE
REC terminals and connect the LINE OUT
terminals to the TAPE PLAY terminals of the
stereo amplifier using RCA pin plug cords.
O LINE OUT terminals output the compact
disc or cassette deck tape signal. When
both compact disc and tape are played
back, the tape sound has priority.
CD LINE OUT terminals
Connect the CD LINE OUT terminals to the
CD, DAT or AUX terminals of the stereo
amplifier using RCA pin plug cords.
O CD LINE OUT terminals always output
the disc signal.
AD-500
_ 5 _
Caution:
If the CD player interferes with the tuner,
TV reciever, etc., allow a reasonable
distance between them.
∑ Power cord
Be sure to connect the power cord to an
AC outlet which supplies the correct
voltage.
∑ Headphones
When using headphones, connect the
headphone plug into the PHONES jack.
O Adjust the level of the signals output
from the phones jack.
Stereo Amplifier