Dometic RC10.4M.90 Notice D'utilisation page 32

Masquer les pouces Voir aussi pour RC10.4M.90:

Les langues disponibles

Troubleshooting

Error and warning indication

All faults are indicated by a warning symbol, a fault ID and a beep. The

beeping lasts for 2 minutes and is repeated every 30 minutes until the

error has been rectified.

RC10.4T.70, RC10.4T.90, RCL10.4(E)T, RCD10.5(X)T, RCS10.5(X)T

Faults are indicated by a fault code with a warning symbol (

TFT display.

If multiple faults occur, the fault codes scroll over in the middle of the display.

All faults of the WARNING (W) type are reset automatically once the fault has been

All faults of the ERROR (E) type must be reset manually:

➤ Press the control knob for at least 2 seconds.

✔ A beep sounds.

✔ The error has been reset.

Defective temperature sen-

sor in the refrigerator com-

Communication error

CI bus fault

Door open for more than

DC voltage <7.5 V

DC voltage <10.9 V

Outer fan overcurrent

Compressor does not start

Compressor overload

Thermal cut out compressor

controller unit

RC(S)(L)(D)10-Series

) in the middle of the

➤ Contact an authorized cus-

tomer service point.