1. Safety Instructions; Warnings - Cooper Hand Tools Weller WDD 81V Manuel D'utilisation

1. Safety instructions

The manufacturer assumes no liability for uses other than those described in the operating
instructions, or for unauthorized alterations. These operating instructions and warnings
should be read carefully and kept in an easily visible location in the vicinity of the soldering
iron. Non-observance of these warnings can result in accidents, injury or risks to health.
The WELLER soldering station WDD 81V is in compliance with the EC Declaration of
Conformity in accordance with the basic safety requirements specified by Directives
89/336/EEC and 73/23/EEC.

Warnings

1. The power cord should be inserted only in specially approved power sockets or
adapters.
2. Keep your work area in proper order.
Always return the soldering tool to its original holder when not in use. Do not bring com-
bustible materials near the hot soldering tools.
3. Take care for the surroundings.
Don't use the soldering tool in a moist or wet environment.
4. Protect yourself against electrical shocks.
Avoid touching grounded parts with your body, e.g. pipes, heating radiators, stoves, refri-
gerators.
5. Keep children at a distance.
Don't allow other persons to touch or disturb the soldering tool or cord. Keep other persons
away from your work area.
6. Store your soldering tool in an appropriate place
Unused soldering tools should be stored in a dry location which is out of the reach of child-
ren (some place high or in a locked cabinet). Switch off all unused soldering tools.
7. Do not overload your soldering tool.
Use the soldering tool only with the specified voltage or specified pressure and pressure
range.
8. Use the appropriate soldering tool.
GB
Don't use a soldering tool whose performance is not adequate for your work. Never use the
soldering tool for purposes for which is was not designed.
9. Wear suitable work cloths.
There is a danger of burning yourself with liquid solder. Wear the corresponding protective
clothing in order to protect yourself against burns.
10. Protect your eyes.
Wear protective eyewear. When working with bonding agents, it is particularly important to
observe the warning notices of the bonding agent manufacturer. Protect yourself against
spattering solder. There is a danger of burning yourself with liquid solder.
11. Use a soldering vapour suction device
If devices for solder vapour suction are available, ensure that these are connected and cor-
rectly used.
12. Do not use the cord for purposes for which it is not designed.
Never carry the soldering tool by the cord. Don't use the cord to pull the power plug from
the socket. Protect the cord from heat, oil, and sharp edges.
13. Protect the work piece.
Use clamping devices to hold the work piece in place. This is more secure than using your
hands, and leaves both hands free to work with the soldering tool.
14. Avoid abnormal posture.
Set-up your work place with proper ergonomics. Avoid bad posture when working. Always
use the suitable soldering tool.
15. Take care of your soldering tool.
Keep the soldering tool clean for better and safer work. Follow the maintenance instructions
and the notices concerning changing the soldering tips. Regularly inspect all connected
cords and hoses. Repairs should only be carried out by a qualified technician. Use only ori-
ginal WELLER replacement parts.
16. Remove the power plug from the socket before opening the unit.
17. Remove all maintenance tools .
Before switching on the unit, check that all maintenance tools have been removed from the
unit.
25