Ravelli RBH 150 V Manuel D'utilisation Et D'entretien page 96

Rev.2 14/01/2021
Pag.40
Settings > Language
To access the next setting, follow the steps given above or simply remove and replace the batteries.
The device resets and prompts you again to select the language you want to set.
Settings > Adjust
DATE-TIME
ENABLE EXT. T
SEASON
CONTRAST
FW VERSION
LANGUAGE
ADJUST
Press the key
"confirm" to
access the
SETUP
SETTINGS
Use the UP/DOWN keys to change the value read by the
room temperature probe installed inside the handheld
set, with respect to a reference value.
The value can vary from -10°C to 10°C.
The standard value is 0°C.
VENTILATION menu (function only for models in which the same is specified in the dedicate user's manual)
The stoves equipped with ventilation system can heat the area in which are installed through the heat generated by the window and
the room temperature fan installed inside them.
Below are the messages shown on display when the stove is equipped with ventilation system.
The temperature read by the handheld unit controls the modulation of the stove. If you want to adjust the ventilation by
adjusting the stove, set the fan to A mode as shown in the relative chapter.
Press the key
"access menu" to
access the
MENU page
To exit the page and return to Stand-by page, press the button repeatedly.
Management: Ventilation can be set from 1 (minimum value) to 3 (maximum value). If you set value A (automatic), the ventilation
follows the set power of the stove.
Chrono function
By enabling the chrono function, it is possible to control the ventilation speed for each program as shown in the logic above.
MENU
USER
MANUFACTURER'S
TECHNICIAN
Press the key
"access menu" to
access the
MENU page
All manuals and user guides at all-guides.com
Use and maintenance manual RBH 150 V - RBH 200 V
Press the key
"selection" to switch
to the function
VERSION FW.
MENU
USER
MANUFACTURER'S
TECHNICIAN
VENTILATION POW.
Press the key
"confirm"
to access the
USER page
DATE-TIME
ENABLE EXT. T
SEASON
CONTRAST
FW VERSION
LANGUAGE
ADJUST
By pressing the following key you will confirm of data
and switch to the page within SETTINGS menu
USER
POWER SETTING
CHRONOTHERMOSTAT
SCREW LOADING
SET AIR-PELLET
Press the key
"confirm"
to access the
USER page
Press the increase/decrease keys
"increase/decrease"
to change the ventilation.
USER
POWER SETTING
CHRONOTHERMOSTAT
SCREW LOADING
SET AIR-PELLET
CRONO-THERMOSTAT.
ADJUST
Press the key
"confirm"
to access the function
Press the key
"confirm"
to quickly switch to
VENTILATION.
POWER SETTING
CHRONOTHERMOSTAT
SCREW LOADING
SET AIR-PELLET
Press the key
several times
to quickly switch to
USER