JVC KD-SH77 Manuel D'instructions page 16

Storing your own sound
adjustments
You can adjust the sound modes to your preference
and store your own adjustments in memory
(USER 1, USER 2 and USER 3).
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step 1 again.
1
Press EQ.
Ex.: When you have selected "POP" previously
2
Press SEL (select) to select sound
elements to adjust.
LOW FREQ.* = LOW WIDTH = LOW LEVEL =
MID FREQ.* = MID WIDTH = MID LEVEL =
HIGH FREQ.* = HIGH LEVEL =
(back to the beginning)
FREQ. (LOW, MID, HIGH):
Select the center frequency to adjust.
WIDTH (LOW, MID):
Select the band width level (Q).
LEVEL (LOW, MID, HIGH):
Adjust the enhancement level.
* By pressing ¢
can directly move as follows:
LOW FREQ.
3
Adjust the selected sound element.
• Refer to the table below for adjusting the
selected sound element.
16
EN14-16.KD-SH77_55[J]f
The last selected sound mode
is recalled, and it is applied to
the current source.
Each time you press the
button, the sound elements
to adjust change as follows:
4, you
or
MID FREQ.
HIGH FREQ.
16
4
Repeat steps 2 and 3 to adjust the
other sound elements.
5
Select one of the user sound modes
(USER 1, USER 2, USER 3).
Ex.: When you select "USER 2"
6
Press EQ to store the adjustments.
To reset to the factory settings
Repeat the same procedure and reassign the
preset values listed in the table on page 28.
Indication
LOW
50 Hz
FREQ.
80 Hz
120 Hz
1 (min.)
WIDTH
|
4 (max.)
–06 (min.) –06 (min.)
LEVEL |
+06 (max.) +06 (max.) +06 (max.)
01.1.9, 4:32 PM
Preset values
MID HIGH
700 Hz 8 kHz
1 kHz 12 kHz
2 kHz
1 (min.)
|
2 (max.)
–06 (min.)
| |