Publicité
Les langues disponibles
Les langues disponibles
english
WARNING: Use only D
packs and chargers.
Inserting and Removing the
Battery Pack from the Tool (fig. 3)
NOTE: For best results, make sure your battery
pack is fully charged.
TO INSTALL THE BATTERY PACK
1. Align the battery pack (m) with the rails inside
the vacuum's battery port (j).
2. Slide the pack into the battery port until the
battery pack is firmly seated in the battery port
and ensure that it does not disengage.
TO REMOVE THE BATTERY PACK
1. Press the battery release button and firmly pull
the battery pack out of the port.
2. Insert battery pack into the charger as
described in the charger section of this manual.
FUEL GAUGE BATTERY PACKS (FIG. 3)
Some D
WALT battery packs include a fuel gauge
e
which consists of three green LED lights that
indicate the level of charge remaining in the battery
pack.
To actuate the fuel gauge, press and hold the fuel
gauge button (n). A combination of the three green
LED lights will illuminate designating the level of
charge left. When the level of charge in the battery
is below the usable limit, the fuel gauge will not
illuminate and the battery will need to be recharged.
NOTE: The fuel gauge is only an indication of the
charge left on the battery pack. It does not indicate
tool functionality and is subject to variation based
on product components, temperature and end-user
application.
Connecting the Hose (fig. 4)
VACUUM MODE
1. Insert the notched connecting piece (o) into the
vacuum inlet (d).
2. Turn the connecting piece clockwise to fix the
hose into position.
3. Connect the appropriate accessory to the hose
nozzle (k).
BLOW MODE
1. Insert the notched connecting piece (o) into the
blow outlet (e).
2. Turn the connecting piece clockwise to fix the
hose into position.
3. Connect the appropriate accessory to the hose
nozzle (k).
34
All manuals and user guides at all-guides.com
OPERATION
WALT battery
e
Instructions for Use
Switching On and Off (fig. 1)
To switch the appliance on, set the on/off switch (a)
to position I.
To switch the appliance off, set the on/off switch (a)
to position O.
Power Source
This vacuum runs either on mains power or battery
power. The vacuum will switch between AC (mains)
and DC (battery) power automatically.
MAINS POWER
1. Fully unwind the mains cable.
2. Connect the plug to the mains outlet before
BATTERY POWER
1. Tidy the mains cable.
2. Insert a battery pack (m).
3. Make sure the battery pack is properly seated.
NOTE: The mains cable power source is only
designed to power the operation of the vacuum and
will not charge an installed battery pack.
Vacuuming (fig. 1, 5–7)
1. Empty and clean the tank (c) before use.
2. Connect the hose ( i ) to the vacuum inlet (d).
3. Select the appropriate accessory.
NOTE: We recommend not mixing wet and dry
substances. When switching substances, empty
and clean the tank first.
WARNING : Always observe the safety
instructions and applicable regulations.
WARNING : To reduce the risk
of serious personal injury, turn
appliance off and disconnect
appliance from power source
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up can
cause injury.
turning the appliance on.
• Always turn the vacuum off when work is
finished and before unplugging.
• Tidy the mains cable when the vacuum is
not in use.
Publicité
