AL-KO KE 1800/35 Mode D'emploi page 16

3 Assembly
The package is produced of recyclable material.
Please, let properly liquidate the package mate-
rial.
3.1 Model KE 1800/35
3.1.1 Guide Bar Assembly
1. Release chain brake. Pull the chain brake lever (1/1)
to the front handle.
2. Remove retaining nuts (1/2) of the chain wheel
cover and remove the cover.
1. Using a screwdriver, run the adjustment screw (2/1)
counterclockwise until the tang (2/2) (projecting
prong) is to the end of its travel toward the clutch
drum and sprocke.
GB 4
All manuals and user guides at all-guides.com
1.
3.1.2
1.
2.
3.
4.
Place the slotted end of the guide bar over the 2 bar
bolts (3/1). Position the bar so that the adjustment
tang fits into the lower hole (2/2) on the guide bar
(3/2).
Saw Chain Assembly
Before all works on the guide bar and the saw
chain:
pull the mains plug
−
put protective gloves on.
−
Watch the saw chain run direction.
Cut edges of the saw teeth on the top side of
the guide bar lead to the front to the reversible
star (the end of the bar).
Slip the chain around the sprocket (5/1) and into the
groove on the guide bar.
Guide the saw chain around the reversible star con-
currently pull the saw chain slightly in the direction
of the arrow.
Guide the chain over the chain catcher (5/2). The
saw chain may droop slightly on the lower part of
the bar.
Tighten the chain tension screw (2/1) until the saw
chain edges the lower part of the guide bar. Screw
to the right.