After Sales Service; Contact In Case Of Malfunction; Warranty; Electrical Connection For The Uk - Miele Classic C1 SB 3 Série Mode D'emploi

After sales service

Contact in case of malfunction

In the event of any faults which you
cannot remedy yourself, please contact
your Miele Dealer or Miele Service.
Contact information for Miele Service
can be found at the end of this docu-
ment.
Please note that telephone calls may be
monitored and recorded for training
purposes and that a call-out charge will
be applied to service visits where the
problem could have been resolved as
described in this booklet.

Warranty

The appliance warranty is valid for 2
years from date of purchase. In the UK,
you must activate your cover by calling
0330 160 6640 or registering online at
www.miele.co.uk.
For more information on country spe-
cific warranty terms and conditions,
please contact Miele Customer Service.
Electrical connection for
the UK
All electrical work should be carried out
by a suitably qualified and competent
person in strict accordance with current
national and local safety regulations (BS
7671 in the UK). The voltage and fre-
quency are given on the data plate loc-
ated underneath the vacuum cleaner.
Please ensure that these match the
household mains supply. The fuse rat-
ing is quoted on the plug. The appli-
ance is supplied with a cable and moul-
ded plug ready for connection to a
230-240 V/50 Hz a.c. single phase sup-
ply.
Non-rewireable plugs BS 1363
The fuse cover must be re-fitted when
changing the fuse, and if the fuse cover
is lost the plug must not be used until a
suitable replacement is obtained. The
colour of the correct replacement cover
is that of the coloured insert in the base
of the plug, or the colour that is em-
bossed in words on the base of the
plug, (as applicable to the design of
plug fitted). Replacement fuses should
be ASTA approved to BS1362 and have
the correct rating. Replacement fuses
and fuse covers may be purchased
from your local electrical supplier.
Electrical connection AU,
NZ
All work should be carried out by a suit-
ably qualified and competent person in
strict accordance with national and
local safety regulations. The voltage
and rated load are given on the data
plate located underneath the vacuum
cleaner. Please ensure that these match
the household mains supply. The appli-
ance is supplied with a cable and moul-
ded plug ready for connection to a
230V/50Hz AC single phase supply.
Test Marks
Electrically sup-
pressed
according to
en
Electrical safety
RCM Mark
AS/NZS CISPR
14.1
45