Problem Solving Guide - Miele Classic C1 SB 3 Série Mode D'emploi

en

Problem solving guide

Many malfunctions and faults that can occur in daily operation can be easily
remedied. Time and money will be saved because a service call will not be
needed.
The following guide may help you to find the reason for a malfunction or a fault,
and to correct it.
Problem
The vacuum cleaner
switches off automatic-
ally.
44
Cause and remedy
A temperature limiter switches the vacuum cleaner off
automatically if it gets too hot.
This can occur if, for instance, large articles block the
suction tube or when the dustbag is full or contains
particles of fine dust. A heavily soiled exhaust or dust
compartment filter can also be the cause of overheat-
ing.
 Switch the vacuum cleaner off immediately using
the On/Off foot control . Disconnect from the
electricity supply. Switch off at the wall socket and
unplug it.
After removing the cause, wait for approximately 20 -
30 minutes to allow the vacuum cleaner to cool down.
It can then be switched on again.