JVC DLA-G150CLE Manuel D'instructions page 39

I Remote control unit
QUICK
ALIGN.
HIDE
W W
SCREEN SCREEN FREEZE
S S
PC1 PC2
DIGITAL ZOOM
T
T/W button
DIGITAL
KEYSTONE
ZOOM
W
PRESET
PRESET button
EXIT button
EXIT
RM-M160 REMOTE CONTROL UNIT
FREEZE message
FREEZE
FREEZE inhibit message
FREEZE
DIGITAL ZOOM inhibit message
D.ZOOM
All manuals and user guides at all-guides.com
OPERATE
COMP VIDEO
FREEZE button
DVI Y/C
T
ZOOM FOCUS
W
MENU
Cursor buttons
5/∞ / 2/3
ENTER
Displaying a Still Picture (FREEZE)
While projecting an image, a still picture is obtained at any
time by using the FREEZE button on the remote control.
When you press the FREEZE button:
"FREEZE" appears on the screen for a few seconds and
then the still picture is shown on the screen. Refer to the
FREEZE message shown on the left of this page.
* To forcibly clear "FREEZE", press the EXIT button.
When you press the FREEZE button again.
The original image resumes.
Remote control unit
FREEZE
Notes
• During freezing, the picture sent from the signal source is
lost.
• If any of the inoperative buttons ("MENU", "QUICK ALIGN.",
"KEYSTONE") are pressed while displaying a still picture,
"FREEZE" is displayed on the screen.
• This function will not work with some signal sources
(UXGA, etc). In this case, the FREEZE inhibit message
appears for a few seconds, as shown on the left. To forcibly
clear this message, press the EXIT button.
Zooming a Part of the Image
(DIGITAL ZOOM T/W)
A part of the image being projected can be digitally magnified up
to four times. When the DIGITAL ZOOM T or W button is
pressed, "Digital zoom" appears on the screen together with the
level bar and magnifying power (×1.0, ×1.2, ×1.4, ×1.6, ×2.0,
×2.5, ×3.2, ×4.0). When "15 sec." is displayed in the menu,
"Digital zoom" will appear in approximately 15 seconds.
Digital zoom 1.2
• To zoom up or zoom down, press the DIGITAL ZOOM T or
W button on the remote control.
Remote control unit
T
DIGITAL
ZOOM
W
Moving the zoomed image:
While "Digital zoom" appears on the screen, you can move
the zoomed image with the cursor (5/∞/2/3) button on the
remote control.
5: Upper part of the image will be
displayed.
∞: Lower part of the image will be
displayed.
2: Left side part of the image will
be displayed.
3: Right side part of the image
will be displayed.
Notes
• This function will not work with some signal sources
(UXGA, etc). In this case, the DIGITAL ZOOM inhibit
message appears for a few seconds, as shown on the left.
To forcibly clear this message, press the EXIT button.
• The quality of the zoomed image reduces in comparison
with the original one.
• To return to the original size (×1.0) and original position,
press the PRESET button while "Digital zoom" is displayed
on the screen.
Basic Operations
37