JVC DLA-G150CLE Manuel D'instructions page 34

Basic Operations
I Projector's buttons
STAND BY
LAMP TEMP
OPERATE
HIDE
PC
KEYSTONE
VIDEO
PRESET MENU
EXIT ENTER
I Remote control unit
QUICK
ALIGN. OPERATE
HIDE
W W
SCREEN SCREEN FREEZE COMP VIDEO
S S
PC1 PC2 DVI Y/C
T T
DIGITAL
KEYSTONE ZOOM FOCUS
ZOOM
W W
PRESET MENU
EXIT ENTER
RM-M160 REMOTE CONTROL UNIT
32
All manuals and user guides at all-guides.com
The following describes the basic procedure for normal use
of the projector.
STAND BY indicator
1. Turning on the Power
OPERATE indicator
OPERATE button
1
2
Notes
• After the power is turned on, the image may be jumbled for
a few seconds, but this is not a malfunction.
• After the indicator comes on, it can take a minute or so for
the lamp to warm up and operate consistently.
I Turning off the Power
1
OPERATE button
Note
• The OPERATE button will not work for approximately 1
minute from when the light-source lamp is turned on. Use
the button after approximately 1 minute.
2
CAUTION
• Do not turn off the MAIN POWER switch during cool-down
mode (the STAND BY indicator blinking). Turn it off after
the STAND BY indicator becomes on (stand-by mode).
Turn on the MAIN POWER switch.
ON [ ❙ ❙ ❙ ❙ ]:The main power turns on and the STAND BY
indicator comes on.
Press the OPERATE button for one
second or more.
• The OPERATE indicator lights and the projected
screen slowly appears.
Remote control unit
OPERATE
or
Press the OPERATE button for one
second or more.
• The STAND BY indicator changes to blinking, and the
projector goes into cool-down mode. The cool-down
mode will continue for approximately 120 seconds.
Remote control unit
OPERATE
Turn off the MAIN POWER switch after
the STAND BY indicator changes to
steady on.
OFF [‡ ‡ ‡ ‡ ]:The MAIN POWER switch turns off and the
STAND BY indicator goes off.
Projector's indicator
STAND BY
OPERATE
Projector
STAND BY
OPERATE
(Blinking)
Projector
STAND BY
OPERATE
Projector
STAND BY
OPERATE