Black & Decker KS900S Traduction Des Instructions D'origine page 8

ENGLISH
Vibration
The declared vibration emission values stated in
the technical data and the declaration of conformity
have been measured in accordance with
a standard test method provided by EN 60745 and
may be used for comparing one tool with another.
The declared vibration emission value may also be
used in a preliminary assessment of exposure.
Warning! The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which
the tool is used. The vibration level may increase
above the level stated.
When assessing vibration exposure to determine
safety measures required by 2002/44/EC to
protect persons regularly using power tools in
employment, an estimation of vibration exposure
should consider, the actual conditions of use and
the way the tool is used, including taking account
of all parts of the operating cycle such as the times
when the tool is switched off and when it is running
idle in addition to the trigger time.
Labels on tools
Warning! To reduce the risk of injury, the
user must read the instruction manual.
Electrical safety
This tool is double insulated; therefore
no earth wire is required. Always check
that the power supply corresponds to the
voltage on the rating plate.
♦ This appliance is not intended for use by young
or infi rm persons without supervision. Children
must be supervised to ensure they do not play
with the appliance.
♦ If the supply cord is damaged, it must be
replaced by the manufacturer or an authorised
Black & Decker Service Centre in order to
avoid a hazard.
Additional safety instructions for non-
rechargeable batteries
♦ Never attempt to open for any reason.
♦ Do not store in locations where the temperature
may exceed 40°C.
♦ When disposing of batteries, follow the
instructions given in the section "Protecting the
environment".
8
All manuals and user guides at all-guides.com
Do not incinerate the batteries.
♦ Under extreme conditions, battery leakage may
Additional safety instructions for lasers
♦ This laser complies with class 2 according to
♦ Do not use the laser for any purpose other than
♦ An exposure of the eye to the beam of a class
♦ Never look into the laser beam directly and
♦ Do not use optical tools to view the laser beam.
♦ Do not set up the tool where the laser beam
♦ Do not let children come near the laser.
Features
1. Lock-on button
2. On/off switch
3. Blade storage compartment cover
4. Shoe plate locking lever
5. Dust extraction outlet
6. Dust extraction adaptor
7. Shoe plate
8. Auto Select™ dial
9. Blade support roller
10. Tool-free blade clamp
occur. When you notice liquid on the batteries,
proceed as follows:
- Carefully wipe the liquid off using a cloth.
Avoid skin contact.
Read all of this manual carefully.
This product is not to be used by
children under 16.
Laser radiation.
Do not look into the laser beam.
Do not use optical tools to view the
laser beam.
EN60825-1:2007. Do not replace a laser diode
with a different type. If the laser is damaged,
have the laser repaired by an authorised repair
agent.
projecting laser lines.
2 laser is considered safe for a maximum of
0.25 seconds. Eyelid refl exes will normally
provide adequate protection. At distances
greater than 1m, the laser complies with class
1 and is therefore considered completely safe.
intentionally.
can cross any person at head height.