Wireless Siren Coding Encryption - Evolu7 Solar Guide D'utilisation

Operating method: [41][1] [#]
LCD display:
Note: after activating this function, do as follows to set the wireless
siren with the alarm panel.
Input [411#], and then make the siren you want to set into coding
status, finally press [0#] on the panel.
Pressing [0#] means the panel will make coding signal to the siren,
this signal will last for 3 seconds. So please make sure the siren is in
coding status during this 3-second period.

42. Wireless Siren Coding Encryption

If you and your neighbor both are using this product, the alarm signal
from your neighbor may cause your siren sound. So it is recommended to
encrypt the wireless siren to avoid the interference.
In setup status, use keypad to input [43], then input the number [01] ~
[99], and then input [#] to confirm. You will hear a long beep and a voice
prompt "setting completed".
Operating method: [43][A][#]
A indicates: the code number 01~99
For example: set the wireless coding number as 10
Operating method: [43][10] [#]
LCD display:
43. Time Setting of Out Arm Delay (Default: 60 sec)
In setup state, input the command: 44 + [XX] + #
XX indicates: the delay time of out arm; XX= 01-99: 1 sec to 99 sec
Note: The setting is effective only with the panel keyboard operation. The
operation by remote controller or SMS is immediate arm without delay.
63