Evolu7 Solar Guide D'utilisation page 70

the detectors of the host are always working; when the detector is
triggered by detecting source (anti-theft, fire prevention, gas leak, etc.),
the alarm system will sound the alarm.
Press [Out Home
second and totally 60 beeps. The [OUT ARM] indicator will be on
without flashing. It means Out Arm is set successfully.
Arm Operation: Press [Out Home
status 60seconds later.
LCD display:
You can also set out arm by SMS remotely. The SMS command is:
Remote Control Password (Default: 1234) + [1]
After the setting, the host makes a "Di" sound, ARM LED is on and you
will receive a SMS: System armed.
16. Disarm
It means to stop the alarm when the main unit sounds the alarm or make
the alarm system in the state of non-warning. After disarming, even if you
trigger the detector, the main unit would not sound alarm (excluding
24-hour defense areas).
Use keypad to input system password, then press [#] button. [Out Home]
or [At Home] lights will be off. It means disarm setting successful.
Remote Control Operation: Press [
Main Unit Operation: input system password + [#]
LCD display:
You can also set disarm by SMS remotely. The SMS command is:
Remote Control Password (Default: 1234) + [2]
After the setting, the host makes "Di" Di" sound, ARM LED is off and
you will receive a SMS: System disarmed.
] button on keypad, system will make a beep per
] button, the system will enter arm
] button on remote controller
70