Evolu7 Solar Guide D'utilisation page 66

the siren when system alarms, you can do it by defense zone
programming. In setup state, first input [60], then the defense zone
number [01~99], then input defense zone type [1~4], then input alarm
type [1~8], and then select siren on/off [0/1], at last press [#] to confirm.
You will hear the main unit emit a long beep and a voice prompt "setting
completed".
Operating method: [60] [AA] [B] [C] [D] [#]
AA: defense zone number
B: defense zone type
[1]: real-time defense zone
[3]: 24 hours defense zone
C: alarm type
[1] SOS Alarm
[4] Door Alarm
[7] Balcony Alarm
After setting the alarm type, the corresponding alarm type icon will be
shown on the LCD screen when alarming. And you will hear the alarm
type voice prompt when answering the alarm call.
D: siren ON/OFF: [0] OFF, [1] ON
For example: set defense zone 12 to be 24-hour, fire alarm and siren on
Operating method: [60] [12] [3] [2] [1] [#]
51. Home Arm Defense Zone Setting
Home arm defense: sometimes (for example, when you are at home), you
want some of the sensors work while some do not, you can do this
setting.
In setup state, use keypad to input [61], then choose the corresponding
defense zone number [01~99], then choose [Home Arm], and then
choose whether alarm [0/1] button, and finally press [#] to confirm. The
main unit will make a long beep and a voice prompt "setting completed".
Operating method: [61]  [XX]  [A]  [#]
XX indicates: [01~99] is defense zone 1 to defense zone 99
A indicates: [0] no alarm under home arm status even the sensor is
triggered
[1] alarm under home arm status
[01~99] means zone 1 to zone 99;
[2]: 40 seconds delay defense zone
[4]: bypass defense zone
[2] Fire Alarm
[5] Hall Alarm
[8] Boundary Alarm
66
[3] Gas Leak Alarm
[6] Window Alarm