Evolu7 Solar Guide D'utilisation page 73

You can also check the alarm records by SMS (Max: Latest 9 records).
SMS Check Command: Remote Control Password (Default: 1234) + [3]
Reply SMS:
Eg: Alarm record:
NO1 Zone: 05 TIME: 11-06-25 11:37
(It indicates the first record: wireless zone 5 alarm time)
................
NO9 Zone: 19 Time: 11-06-25 11:45
(It indicates the first record: wireless zone 19 alarm time)
22. GSM Signal Checking
Before installing the main unit, you should check the signal of the
installing place in order to ensure the unit can perform well. In setup
state, input [81]  #, the main unit will make a long beep and display
00+XX (XX indicates the intensity of the signal). And the intensity
should be within the range of 07-31; if it's less than 07, you should
change place.
This icon indicates the signal intensity. When the intensity number
is 0-7, this icon will not be shown; when it's 8-15, this icon will be
flashing; when the number is larger than 16, this icon will be on the
screen without flash.
For example: if the signal intensity is 12, it will display as:
Note:
Only under Out Arm status, the system has the function of sending SMS
alert for power failure/ power recovery. While in Disarm or Home Arm
status, it does not.
The SMS content:
Power failure: Power charger off
Power recovery: Power charger on
73