Evolu7 Solar Guide D'utilisation page 65

47. SMS Receiving Number Setting
SMS Receiving number means when system is alarming, it will only
send SMS to this mobile number. You can set maximum 3 SMS numbers.
In setup state, input [57] ~ [59], then input the SMS receiving number,
and then press [#] button to confirm. The main unit will make a beep, the
[Signal] indicator will flicker once and you will hear "setting completed",
which indicate setup successfully.
Operating method: [XX]  [YY...YY]  [#]
XX indicates: address codes of message-receiving numbers from the first
group to the third group [57] ~ [59]
YY...YY indicates: the SMS receiving number
For example: setup 13822222222 as the first SMS receiving number
Operating method: [57]  [138222222]  [#]
48. Delete SMS Receiving Number
In setup state, use keypad to input [57] ~ [59], and then press [#] button
to confirm. The main unit will make a beep, the [Signal] indicator will
flicker once and you will hear "delete completed", which indicate SMS
number is deleted successfully.
Operating method: [XX]  [#]
XX indicates: address codes of message-receiving numbers from the first
group to the third group [57] ~ [59]
For example: delete the first SMS user number from the system
Operating method: [57]  [#]
49. SMS Notification for Arm/Disarm (Default: OFF)
In setup state, input the command [77] + [1/ 0] + [#]
After starting this function, the system can send SMS to three SMS
receiving numbers (57~59 as mentioned above) when the system enters
arm/ disarm status through wireless remote controllers or its panel
keyboard operation.
50. Defense Zone Programming
If you want to change the alarm attribute of defense zone, such as turn off
65
(1: ON, 0: OFF)