Evolu7 Solar Guide D'utilisation page 56

6 Zone 2
7 Zone 3
8 Zone 4
9 Zone 5
10 Zone 6
1 SIM
2 Siren
3 Power
4 Switch
Note:
"LB-" and "LB+" are to connect external speaker. If you think the
4.
internal speaker is not loud enough, please contact us for professional
speakers.
5. Connect one cable of the wired sensor to GND and the other to
"Z1/Z2/Z3.../Z6".
6. Please pay attention to the siren connection. Do not mix the two cables
together when connecting. Otherwise, it will damage the transistor in the
main panel.
Door sensor
Door sensors are used for detecting the status of open and close of windows
and doors. It will detect it and send the signal to main panel.

Tear apart the double-side adhesive tape on the magnet and the
transmitter. Then adhere them to the appropriate position.

Magnet should be near to the side of transmitter with indicator. The two
should align with each other and the
distance should not exceed 10mm.
Wired sensor 2: support both NO and NC
Wired sensor 3: support both NO and NC
Wired sensor 4: support both NO and NC
Wired sensor 5: support both NO and NC
Wired sensor 6: support both NO and NC
Put SIM card in this card slot
Plug in siren connector
Connect to the external power supply
Switch for backup battery. Turn it on
after power on.
56