Charging The Battery - Invacare Aquatec Ocean E-VIP Mode D'emploi

Assembly and installation
5. Use one hand to push back unlocking tab B on the top of battery
pack C .
6. With your other hand, lift the battery pack approx. 5 mm and
draw it out approx. 10 mm.
7. Remove the battery pack from control box A with twist and tilt
movement.

4.11 Charging the battery

The product cannot be used while the battery is charging.
The battery can be charged with the electronics cover attached or
detached and when the battery pack is removed.
WARNING

▸ Never throw the battery pack into the fire or store it near
naked flames.
▸ Never open the battery pack. Opening the battery pack will
void the warranty.
▸ Only connect the charger to the mains when the battery
pack is connected to the charger.
Shower and Toilet Commode Ocean E-VIP
CAUTION Risk of electric shock!

▸ Only recharge the battery in dry rooms and never in the
bathroom.
▸ With the electronics cover removed after charging, close off
the socket on the battery pack with the dust cap.
!
IMPORTANT
▸ Only use the charger supplied (Aquatec®Ocean E-VIP) to
charge the battery in the battery pack.
▸ Make sure that the voltage specifications shown on the
charger correspond to those of the mains supply.
▸ Follow the instructions in Section 7.3 on how to maintain
the service life of the battery when not in use for a lengthy
period.
G
1. Detach cap C from socket B on battery pack A.
!
IMPORTANT
When the electronics cover is fitted, the charging socket is to
the front (not to the side).
2. Fully insert connector D of charger E into socket B on the battery
pack.
3. Insert mains plug F of the charger into an approved power socket.
13