Connecting On Adr Lan1 Card A1 - Sagem ADR 155C Guide D'installation Et D'utilisation

1 - INSTALLATION AND COMMISSIONING
1.3.4 - Connecting on ADR LAN1 card
ADR LAN1
STATUS
LED
Green Red
ON OFF
ON ON
OFF OFF
OFF ON
Flashing
ETH
Contact 1
1 : TX_ETH_TIP 5 : NC
2 : TX_ETH_RING 6 : RX_ETH_RING
3 : RX_ETH_TIP 7 : NC
4 : NC 8 : NC
Yellow LED : link status
ON : correct link
Green LED : traffic status
ON : on reception
"ETH" Interface :
Port
Connector
Pin N°
1
2
3
4
5
6
7 and 8
NOTE: Two LEDs are linked to the "ETH" interface:
• LED, "Activity", green colour
• LED, "Link", yellow colour
Electrical characteristics compliant with the IEEE 802.3U
Installation and User Guide - N56717020101
Page A1-16
No reproduction or communication without the written consent of SAGEM SA
STATUS
Card in service
Card in alarm
Hardware default (fuse)
Card out of service
Autotest default
Contact 8
NC : Reserved
Figure 1-5 – Connecting ADR LAN1 card input
Traffic Ethernet interface operating at 10 or 100 Mbit/s in half-duplex or full-
duplex mode according to the mode used by the interlocutor (dynamic
adaptation of the Ethernet port on each new log-in of the interlocutor),
Ethernet 10 or 100 BaseT - RJ48 Type (Shielded RJ45).
Pin 1
Signal name
TX_ETH_TIP
TX_ETH_RING
RX_ETH_TIP
NC
NC
RX_ETH_RING
NC
10 / 100 HALF FULL
/
ETH
Yellow LED : Ethernet interface type
ON
Yellow LED : Ethernet interface bite rate
Pin 8
Front view
Ethernet output (hot point)
Ethernet output (cold point)
Ethernet input (hot point)
Reserved
Reserved
Ethernet input (cold point)
Reserved
: Trafic status indicator,
: Link status indicator.
HALF/FULL
(Half or Full Duplex)
: Full duplex
10/100
ON : 100 Mbit/s
Comments