Worx WG789E Traduction Des Instructions Initiales page 17

STORAGE (See S)
Stop the mower and always remove the
safety key. Clean the exterior of the machine
thoroughly using a soft brush and cloth. Do
not use water, solvents or polishes. Remove
all grass and debris, especially from the
ventilation slots.
Turn the machine on its side and clean the
blade area. If grass cuttings are compacted
in the blade area, remove with a wooden or
plastic implement.
Store the machine in a dry place. Do not place
other objects on top of the machine.
TROUBLE SHOOTING
Problem
1. Mower doesn't run when
switch lever is activated.
2. Motor stops while mowing.
3. Mower runs but cutting
performance is unsatisfactory,
or does not cut entire lawn.
4. Mower is too hard to push.
Cordless self-propelled lawn mower
To aid storage, press the handle height
adjustment knob, and rotate or fold the upper
handle.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice.
A. Check to make sure safety key has been installed and
is fully seated and that button on switch housing is being
completely pushed.
B. Release switch lever to turn mower off. Remove safety key,
turn mower over and check that blade is free to turn. Clear
any obstruction. If not free, return to an authorized servicer.
Blade should turn freely.
C. Has battery been fully charged? Plug in charger and wait
for green light to come on.
A. Release switch lever to turn mower off. Remove safety key,
turn mower over and check that blade is free to turn. Clear
any obstruction. If not free, return to an authorized servicer.
Blade should turn freely.
B. Raise cutting height of wheels to highest position and start
mower.
C. Has battery been fully charged? Plug in charger and wait
for green light to come on.
D. Avoid overloading the mower. Slow down the cutting pace
by pushing mower slower or raise the cut height. Or both.
A. Has battery been fully charged? Plug in charger and wait
for green light to come on. "
B. Release switch lever to turn mower off. Remove safety key.
Turn mower over and check: Blade for sharpness - Keep blade
sharp. Deck and discharge chute for clogging.
C. Wheel height adjustment may be set too low for grass
condition. Raise cutting height.
A. Raise cutting height to reduce deck drag on grass. Check
each wheel for free rotation.
Solution
17 17
EN