Arcam FMJ AV8 Mode D'emploi page 36

GENERAL OPERATION COMMANDS
Command Parameters Description
PWR ?zPWRx Power on/off
MUT ?zMUTx Mute on/off
FAN zFANx Force Analogue
EFF ?EFFy
Effect Mode Selection
THX ?THXy THX Mode Selection
DEC ?DECy Decode/Downmix Mode Selection
DIS
VFD Display
RES Restore Preset
INF Current Source information (on OSD)
SIG ?zSIG Current Audio Signal Type
STS ?zSTS Zone Status. Displays current state of
Audio,Video,Volume, Mute, Audio Signal
Type, *Decode/Downmix Mode, *Effect
Mode, *THX Mode.
* Zone 1 only
TRM TRMsy Trim Levels
MAIN MENU COMMANDS
Command Parameters Description
VOL ?zVOLy Volume
PRE PREy Preset Select
AUD ?zAUDi Audio source selection
VID ?zVIDi
Video source selection
VDT VDTy
Video Type
DIR ?DIRix
Stereo Direct
BAL BALy Balance
RCT RCTi Record To Tape Select
RCV RCVi Record To VCR Select
COM COMy Compression
LIP LIPy Lip Sync Control
DIM DIMy
Pro Logic II MusicMode Dimension
CTW CTWy Pro Logic II Music Mode Centre Width
PAN PANx Pro Logic II MusicMode Panorama
HED HEDz Headphone Out
All manuals and user guides at all-guides.com
Parameter values
y may have the values 0 to 7, as follows:
0 = off, 1 = music, 2 = party, 3 = club, 4 = hall, 5 = sport, 6 = church, 7 = next
effect.
y may have the values 0 to 4, as follows:
0 = Off, 1 = THX Cinema, 2 = THX Ultra2 Cinema, 3 = THX MusicMode, 4 =
THX SurrEX.
If Audio Signal Type is Analogue or PCM, y may have the values 0 to 6 as follows:
0 = Mono, 1 = Stereo, 2 = Pro Logic II Movie, 3 = Pro Logic II Music, 4 = Pro Logic,
5 = Neo:6 Cinema, 6 = Neo:6 Music.
If Audio Signal Type is Digital Surround (Dolby or DTS), y may have the values 0 to
2 as follows:
0 = Mono Downmix, 1 = Stereo Downmix, 2 = No Downmix.
y may have a value in the range -10 to +10:
-10 = –10dB
+10 = +10dB
Parameter values
y may have a value in the range -53 to +19:
-53 = –53dB
+19 = +19dB
y may have a value in the range 1 to 5.
y may have the values 0 to 1, as follows:
0 = 4:3, 1 = 16:9.
y may have a value in the range -10 to +10:
-10 = +10dB to Left
+10 = +10dB to Right
y may have the values 0 to 2, as follows:
0 = Off, 1 = Medium, 2 = High.
y may have a value in the range -1 to +44:
-1 = –5ms
+44 = +220ms
y may have a value in the range 0 to 6.
y may have a value in the range 0 to 7.
E-36
E-36