Arcam FMJ AV8 Mode D'emploi page 30

Technical specifications
Audio
Line input sensitivity (set to Reference)
Input impedance
Preamp output level (nominal)
Output impedance
Signal/noise ratio (unwtd 20Hz–20kHz) – analogue
Signal/noise ratio (unwtd 20Hz–20kHz) – digital (24-bit)
THD+N – analogue
THD+N – digital (24-bit)
Headphone maximum output level into 600Ω
Output impedance
Video inputs and outputs
Input and output impedance
Composite video level
HF response to (–3dB)
S-video level (Y/C)
HF response to (–3dB)
HQ (component) video
level (Y / Cr / Cb)
level (R / G / B)
HF response to (–3dB)
Digital inputs
Coaxial connection (level/impedance)
Acceptable sampling frequencies, all inputs
Digital output
Output level/impedance
Sampling frequency in ADC output mode
Trigger outputs
Output D.C. voltage (excl. RGB status)
Allowable load
Remote inputs and output
Signal
Coding
General
Mains voltage range
Power consumption
Power consumption (standby)
Dimensions Width x Depth x Height (including feet)
Weight (net)
Weight (packed)
Supplied accessories
E&OE
NOTE:All specification values are typical unless otherwise stated.
All manuals and user guides at all-guides.com
2V rms
10kΩ
2V rms
25Ω
>100dB
>98dB
0.0012%
0.0015%
5V p-p
5Ω
75Ω
1V
12MHz
1V / 0.28V
12MHz
1V / 0.5V / 0.5V
1V / 1V / 1V
300MHz
0.5V/75Ω
44.1kHz, 48kHz, (and 96kHz stereo only)
0.5V/75Ω
44.1kHz
12V ±1V
30mA max (min 400Ω)
modulated 36kHz carrier
Philips RC-5
85V to 265V
35VA
32VA
433mm x 360mm x 130mm
9kg
14kg
Mains lead, CR80 remote control, 2 x AA batteries
E-30
E-30
CONTINUAL IMPROVEMENT POLICY
Arcam has a policy of continual improvement for its products. This
means that designs and specifications are subject to change without
notice.