Publicité
Les langues disponibles
Les langues disponibles
Remote control
The CR80 remote control is a multi-function unit that controls the AV8
and up to seven other devices.The instructions on this page only refer
to the control of the Arcam FMJ AV8.
For information on using the remote control for other devices, and a
full list of features, see the instruction booklet supplied with the CR80.
Source selection
– DVD input
DVD
SAT
– Satellite input
VCR
– Video Cassette Recorder input
– Compact Disc player input
CD
AUX
– Auxillary (line) input
TAPE
– Tape (monitor) input
– Tuner input
TUN
AV
– AV input
MCH
– DVD-A (multichannel) input
Press the relevant button once to select input; press
and hold to select the analogue input if a digital input
is present.
MUTE
Press once to mute the main system. Press again (or
use
VOL +/–
) to un-mute.
VOLUME +/–
Adjusts the volume.
MODE
Use this button to cycle through available surround
modes.
INFO
Press once to display the OSD report on source
inputs and processing mode.
SYN (Lip sync)
Press once to adjust the Lip sync audio delay. Use
3
and
4
the
navigation buttons.
Press again to exit the Lip sync function.
DIS (Display)
Press to cycle through Off/Dim/Bright illumination
of the front panel display
TRM (Speaker trim)
Press to display the OSD Speaker trim level menu.
TRM allows temporary adjustment of speaker
levels, using the navigation buttons. Press again to
exit the 'Speaker Trim' function.
All manuals and user guides at all-guides.com
Device selection
IMPORTANT: Press the 'AMP' button first to
operate the AV8.
SET
SELECT DEVICE
CBL
DVD
SAT
CD
1
2
DVD
SAT
4
5
CD
AUX
7
8
TUN
AV
0
MUTE
FM
LAST
THX
SLEEP
VOL
FX
A–B
SUB
GUIDE
MODE
OK
INFO
P.MODE
SUBT
P –
P +
ZOOM
AUDIO
TST
SYN
ANGLE
SETUP
STATUS
DIS
TRM
CR80
E-18
E-18
On/Standby
This allows the AV8 to be put into and taken out of
standby remotely.
VCR
TV
AMP
AUX
3
VCR
6
TAPE
THX (THX mode)
9
MCH
Use this button to cycle through available THX
modes.
AM
FX (DSP effects mode)
Use this button to cycle through effects modes for
two-channel sources.
CH
SUB (Subwoofer trim)
Allows a temporary trim of the subwoofer level.
EXIT
Press
SUB
OPEN
the navigation panel.
Navigation buttons
Arrow buttons allow navigation around the menus
on the AV8.
Confirm selection by pressing
MENU
the
button to swap PAL/NTSC OSD modes.
OK
MENU
Press to select the OSD Main menu.
Press and hold for more than two seconds to
TITLE
MENU
select the 'Setup Menu Index'.
TM
FAV
MEM
RETURN
FAV (Favourite)
DYN
SLP
Use this button to clear any temporary
SEARCH
adjustments and return to the current preset
1
2
settings.
The other buttons in this area are used for DVD
and Tuner control and do not effect the AV8.
NOTE
Remember to correctly install the two AA batteries supplied
before trying to use your remote control.
34
, then adjust using the
buttons on
. Press and hold
OK
Publicité
