Bosch PSR 7,2 LI Notice Originale page 30

OBJ_DOKU-27621-003.fm Page 30 Friday, August 29, 2014 5:03 PM
30 | English
switched off by means of a protective circuit: The inserted tool no longer ro-
tates.
 Do not continue to press the On/Off switch after the machine has
been automatically switched off. The battery can be damaged.
The charging procedure starts as soon as the main plug of the battery charger
is inserted into the socket and the cordless screwdriver is afterwards placed
on the battery charger 11.
The battery charge-control indicator 5 indicates the charging progress. Dur-
ing the charging procedure, the indicator flashes green. The battery is fully
charged when the indicator lights up green continuously.
During the charging procedure, the handle of the machine warms up. This is
normal.
Disconnect the battery charger from the mains supply when not using it for
longer periods.
The power tool cannot be used during the charge procedure; it is not defec-
tive when inoperative during the charging procedure.
Observe the notes for disposal.
Changing the Tool (see figure B)
 Do not use double-sided screwdriver bits that are longer than 25 mm.
Insert the screwdriver bit 1 directly into the tool holder 2.
Operation
Starting Operation
To save energy, only switch the power tool on when using it.
Reversing the rotational direction (see figure C)
The rotational direction switch 9 is used to reverse the rotational direction of
the machine. However, this is not possible with the On/Off switch 8 actuated.
Right rotation: For driving in screws, push the rotational direction switch 9
left to the stop.
The indicator for right rotation 4 lights up when the On/Off switch 8
is actuated and the motor is running.
1 609 92A 0UT | (29.8.14) Bosch Power Tools