Bosch PSR 7,2 LI Notice Originale page 31

OBJ_DOKU-27621-003.fm Page 31 Friday, August 29, 2014 5:03 PM
Left Rotation: For loosening or unscrewing screws, push the rotational di-
rection switch 9 right to the stop.
The indicator for left rotation 6 lights up when the On/Off switch 8
is actuated and the motor is running.
Setting the torque
With the torque preselection ring 3, the required torque can be preselected
in 10 steps. The inserted tool is stopped as soon as the set torque is reached.
Position 1:
Lower torque for screwing in screws with small diameter or into soft
materials.
Position 10:
Higher torque for screwing in screws with large diameter or into hard
materials.
Switching On and Off
To start the machine, press the On/Off switch 8 and keep it pressed.
The power light 7 lights up when the On/Off switch 8 is slightly or completely
pressed, and allows the work area to be illuminated when lighting conditions
are insufficient.
To switch off the machine, release the On/Off switch 8.
Adjusting the Speed
The speed of the switched-on power tool can be variably adjusted, depend-
ing on how far the On/Off switch 8 is pressed.
Light pressure on the On/Off switch 8 results in a low rotational speed. Fur-
ther pressure on the switch results in an increase in speed.
Fully automatic spindle locking (Auto-lock)
When the On/Off switch 8 is not pressed, the drill spindle and thus the tool
holder are locked.
This enables screws to be screwed in, even when the battery is empty and al-
lows for the machine to be used as a screwdriver.
Temperature Dependent Overload Protection
When using as intended for, the power tool cannot be subject to overload.
When the load is too high or the allowable battery temperature of 70 °C is
Bosch Power Tools
English | 31
1 609 92A 0UT | (29.8.14)