Festo DGP B Série Notice D'utilisation page 35

DGP(L)−...−B
9 Care and maintenance
Maintaining the band system:
Clean the band system if required with a soft cloth.
S
Cleaning agents: all non−abrasive media.
Lubricate the surface of the band system if it no longer has a layer of grease.
S
Grease type: LUB−KC1 (silicon−free) from Festo.
Lubricating the roller bearing of types DGPL−...:
1. Make sure that the lubrication intervals in accordance with Fig. 32 are
observed. If the device is not operated frequently, lubrication should take
place at the latest after 3 years.
Lubrication intervals and grease types
The first lubrication
The following interval with LUB−KC1
Or: The following interval with LUB−RN2
Fig. 32
S Note that lubrication must be undertaken more often:
in dusty and dirty environments
with work strokes of < 50 mm
at speeds of > 2 m/s.
2. Exhaust the DGPL−... .
3. Grease the roller bearings on all four
lubrication nipples.
For this purpose use a grease gun with
pinpoint nozzle (see Accessories").
S Push the slide backwards and forwards
during lubrication. Otherwise the
grease cavities will not be filled to an
equal extent.
4. Lubricate the surface of the band system if it no longer has a layer of grease
(grease type: see Fig. 32).
Festo DGP(L)−...−B 0407f English
5000 km
400 km
5000 km
Fig. 33
35