Zodiac T3 Instructions D'installation page 14

• The appliance must be cleaned regularly using clean or slightly soapy water. Do not use solvents.
• Rinse the appliance thoroughly with clean water.
• Never store the cleaner in direct sunlight. Store hoses flat, do not wind in order to retain the initial hose shape.
4.1 I Cleaning the filter pump's pre-filter
• Always remove the cleaner from the pool before cleaning or draining the filtration system.
• After cleaning (and before re-immersing the cleaner), start the filter pump and leave to
operate for at least 5 minutes in order to drain the circuit.
• To keep your cleaner operating efficiently, the pump pre-filter needs to be maintained regularly by removing the
debris.
• We recommend using the leaf catcher (accessory available as an optional extra) to collect large debris before it enters
the skimmer and pre-filter.
4.2 I Cleaning the Cyclonic
• Stop the filter pump.
• Hold the leaf trap under the water and grasp its handle. Using the handle, turn the transparent container until it
comes away (see image
• Remove the transparent container from the water and leave the lid and hoses immersed (see image
• Remove the filter using the top handle (see image
• Remove the debris and rinse the transparent container with fresh water (see image
• Reposition the filter then re-immerse the leaf catcher (see image
• Correctly position the transparent container in the notches of the lid, then twist firmly to clip the 2 parts in place (see
image ).
12
❹ Maintenance
Leaf Catcher (available as an optional extra)
TM
).
).
).
).
).