Zodiac T3 Instructions D'installation page 12

3.1 I Operating principle
Hydraulic cleaners are connected to the filtration system (to a suction port or skimmer). They use the energy from the
filter pump to move in the pool.
The cleaner's ability to climb the sides depends on the shape of the pool and the water flow rate available.
Debris is aspirated by the cleaner and captured in the pre-filter of the filter pump or in the leaf catcher (accessory
available as an optional extra).
3.2 I Pool preparation
• This product is intended for use in private, permanent-installation, buried or above-ground,
rigid-wall swimming pools since it cannot be easily disassembled and stored.
• Not for use in pools which may be dismantled.
The appliance must operate in pool water with the following properties:
Water temperature
• When the pool is dirty, especially when first installing the cleaner, remove the largest debris using a manual brush
and a net.
• Remove any thermometers, toys and other objects that might damage the appliance.
• Wait at least 4 hours after adding chemicals to the water before immersing the cleaner.
• Ensure that the filtration system and the skimmer strainers are clean.
• Direct the discharge nozzles downwards if adjustment is possible (see image
• Close the bottom plug hole of your pool.
• Stop the filter pump.
10
❸ Use
pH
Chlorine
Between 15°C and 35°C
Between 6.8 and 7.6
< 3 mg/ l
).