Zodiac T3 Instructions D'installation page 13

3.3 I Operation
• To avoid serious injury, ensure the filter pump is not operating.
• Do not place your hair, loose clothing or jewellery etc. in the vicinity of the open end of the
hose.
3.3.1 Connecting and immersing the cleaner
• Immerse the cleaner so that it becomes filled with water.
• When no more air bubbles are released from the cleaner, connect the hose to the cleaner (see image
• Wait for the cleaner to sink to the bottom of the pool.
3.3.2 Filling the hoses
• Temporarily disconnect the hose from the suction port or skimmer.
• Start the filter pump.
• Fill the hose with water by placing the end in front of a discharge nozzle until it is completely full.
• Stop the filter pump and connect the hose back to the suction port or skimmer.
• Start the pump to switch on the cleaner.
3.4 I Optimising performance
The cleaner follows the filter pump's activation cycles, aspirating and cleaning the entire surface area of the pool by
way of random movements. The rate of coverage of the cleaner depends on the shape of the pool and the water flow
rate available. Adjustments may be necessary in some pools in order to optimise the rate of coverage.
3.4.1 Balancing the hose
• A correctly balanced hose must form a 45° angle between the cleaner and the bottom of the pool.
Incorrect hose balancing*
*See §5.1 I Appliance behaviour.
Correct hose balancing
).
Incorrect hose balancing*
EN
11