Kaco blueplanet 3.0 NX1 M2 Guide Rapide D'installation page 9

Connection area opened.

NOTE: Before proceeding with the isolation ensure that you do not cut any individual wires.

1 Insert isolated wires with twisted ends carefully up to the connection.
NOTE: Wire ends must be visible in the spring.
2 Close the spring so that the spring latches and slide insert into sleeve.
3 Secure and tighten the cable fitting [
»
4 Join insert with contact plug.
Making the electrical connection
Connecting the PV generator
DC plug connector configured and PV generator checked to ensure there

is no ground fault.
1 Remove protective caps from the required DC connection plugs on the
underside of the device.
2 Connect the DC plug connectors to the DC positive and DC negative
»
connectors in pairs.
The device is connected to the PV generator.
1.7 Creating equipotential bonding
NOTE
Depending on the local installation specifications, it may be necessary to earth the device with a second
ground connection. To this end, the threaded bolt on the underside of the device can be used.
The device has been installed on the mount.

1 Insert the grounding conductor into the suitable terminal lug and crimp the contact.
2 Insert the terminal lug with the grounding conductor on the screw.
»
3 Tighten the screw tightly into the housing [
The housing is included in the equipotential bonding
Key
1 M4 terminal lug
2 Earthing ground conductor
1.8 Connecting the WIFI module
NOTE
Damage to the inverter due to electrostatic discharge
Components inside the inverter can be damaged beyond repair by electrostatic discharge.
› Earth yourself before touching the component.
The device has been installed on the mount.

1 Insert the WIFI module into the existing connection and screw it tightly into the
connection using the nut on the module.
2 Ensure that the module is securely connected and that the label on the module
» The WIFI module is connected to the device.
can be seen.
KACO blueplanet 3.0 NX1 M2 KACO blueplanet 3.7 NX1 M2 KACO blueplanet 4.0 NX1 M2 KACO blueplanet 5.0 NX1 M2
W_15/ 1.8 Nm].
P_2/ 1.6 Nm].
3 M4 screw
Fig. 15: Insert the DC connector
Fig. 16: Connecting grounding
Fig. 18: Connecting the WIFI module
Page 6