Limited Two-Year Larranty - Waterpik Sensonic SR-3000 Mode D'emploi

Battery Removal
Note: This process is not reversible
Remove the battery only at the end of the product's
life for recycling. Doing so earlier will destroy the
product. Deplete the battery charge until the brush no
longer operates. Observe basic safety precautions.
Remove the batteries as shown and recycle them and
the rest of the product according to local regulations.
1. Use coin or washer to rotate cap counter-
clockwise until cap protrudes.
2. Push down hard with shaft on hard surface.
3. Remove cap and pull internal body out.
Cut tape and remove.
4. Lift battery pack up and cut battery wires,
one at a time, to free from circuit board.
20019746-FAA_SR3000E1_IM_Revs_rdF.indd 7
Tape
LIMITED TWO-YEAR WARRANTY
Water Pik, Inc. warrants to the original purchaser/
owner of this product that it is free from defects
in materials and workmanship for two years from
date of purchase. Save your receipt as your proof
of purchase date. Water Pik, Inc. reserves the right
to request the product to be returned for analysis to
confirm the claim falls within our warranty policy.
We will replace any part of the product, which in
our opinion is defective, provided the product has
not been abused, misused, altered or damaged
after purchase and was used according to these
instructions. Repair or replacement services provided
for by the guarantee will be carried out by the local
distributor, whose details may be found on
[www.waterpik.com/intl]. Upon request of the
consumer, a copy of the guarantee complete with the
local distributor's information will be provided by email
or mail. This limited warranty excludes accessories or
consumable parts such as brush heads, etc.
This warranty gives you specific legal rights. You may
also have other rights that vary depending on the law
in your place of residence.
To locate your local distributor, go to
www.waterpik.com/intl.
7
12/8/14 2:09 PM