Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Parameterization
8.5
Parameter input with DriveMonitor
NOTE
8.5.1
Installation and connection
8.5.1.1
Installation
8.5.1.2
Connection
RS232 interface
NOTICE
8-14
Please refer to the online help for detailed information on
DriveMonitor (
button or F1 key).
A CD is included with the devices of the MASTERDRIVES Series when
they are delivered. The operating tool supplied on the CD (DriveMoni-
tor) is automatically installed from this CD. If "automatic notification on
change" is activated for the CD drive on the PC, user guidance starts
when you insert the CD and takes you through installation of
DriveMonitor. If this is not the case, start file "Autoplay.exe" in the root
directory of the CD.
There are two ways of connecting a PC to a device of the SIMOVERT
MASTERDRIVES Series via the USS interface. The devices of the
SIMOVERT MASTERDRIVES Series have both an RS232 and an
RS485 interface.
The serial interface that PCs are equipped with by default functions as
an RS232 interface. This interface is not suitable for bus operation and
is therefore only intended for operation of a SIMOVERT
MASTERDRIVES device.
5
9
4
8
3
7
2
6
1
To PC COMx
socket
Fig. 8-5
Connecting cable for connecting PC COM(1-4) to SIMOVERT
MASTERDRIVES X300
DriveMonitor must not be operated via the Sub-D socket X300 if the
SST1 interface parallel to it is already being used for another purpose,
e.g. bus operation with SIMATIC as the master.
5
9
4
8
3
7
2
6
1
Device side
-X300 (compact PLUS -X103)
9-pin SUB-D connector
6SE7087-7KN50
Operating Instructions
SIMOVERT MASTERDRIVES
10.2006
X300:
1 n.c. (not connected)
(Compact PLUS: RS232 Id)
2 RxD (RS232)
3 Rx+/Tx+ (RS485)
4
5 Ground
6 +5V (OP1S)
7 TxD (RS232)
8 Rx-/Tx- (RS485)
9 Ground
Siemens AG
Publicité
Chapitres
Table des Matières
