Siemens 6SE7087-8KN50 Instructions De Service page 337

10.2006
Number / Alarm Cause
A183 The block number for the main program (level
0), which was transferred with block search,
Block no. of block does not exist in the main program.
search fwd l. 0 does
not exist Effect:
NC program execution is inhibited.
A184 The block number for the main program (level
0), which was transferred with block search,
Block no. of block does not contain a subprogram call for
search forward is no subprogram level 1.
UP call
Effect:
NC program execution is inhibited.
A185 The block number for subprogram level 1,
which was transferred with block search, does
Block no. of block not exist in the subprogram.
search forward does
not exist Effect:
NC program execution is inhibited.
A186 The block number for subprogram level 1,
which was transferred with block search, does
Block no of block not contain a subprogram call for subprogram
search fwd lev 1 is no level 2.
SP call
Effect:
NC program execution is inhibited.
A187 The block number for subprogram level 2,
which was transferred with block search, does
Block no of block not exist in the subprogram.
search fwd lev 2 does
not exist Effect:
NC program execution is inhibited.
A188 The remaining loop count transferred with
block search for subprogram level 1 or 2 is
Rem. loop count bl. greater than the programmed loop count.
search fwd lev1/2 not
allowed Effect:
NC program execution is inhibited.
A190 The NC block which was read in contains the
"inprocess measurement" or "set actual value
Digital input not on-the-fly" function, although a digital input
programmed has not been programmed for this function
(machine data 45).
Effect:
NC program execution is inhibited or aborted,
the axis is brought to a standstill via the
deceleration ramp.
A191 Although the "external block change" function
was programmed, the digital input was not
Digital input not actuated in order to trigger the external block
actuated change.
Effect:
The NC program is interrupted, the axis is
brought to a standstill via the deceleration
ramp.
Siemens AG 6SE7087-7KN50
SIMOVERT MASTERDRIVES Operating Instructions
Counter-measure
For the block search function, an existing
block number must be specified as the block
number for the main program.
For the block search function, a block number
with a subprogram call must be specified as
the block number for the main program (level
0) if a block search is to be performed in
subprogram level 1.
For the block search function, a block number
which exists in this subprogram must be
specified as the block number for subprogram
level 1.
For the block search function, a block number
with a subprogram call must be specified as
the block number for subprogram level 1 if a
block search is to be performed in subprogram
level 2.
For the block search function, a block number
which exists in this subprogram must be
specified as the block number for subprogram
level 2.
For the block search function, it is only allowed
to specify a remaining loop count between 0
and the programmed loop count-1.
Program the digital input for the desired
function.
-Correct the program.
-Check the actuation of the digital input.
Faults and Alarms
12-27