Rear Connectors - Axis Q7900 Rack Guide D'installation

Page 10
Unit connectors

Rear connectors

Network Connector - Axis video encoder blades are designed for 10/100/1000 Mbps networks and
connect via the standard RJ-45 connector.
Network Connector Switch - The Network Connector Switch controls which blades are connected
to a particular network connector. The following table shows how the blades are connected based
on how the switches are set. These settings are only made during power up.
NET 1-2 NET 2-3
switch switch
Off Off
On Off
Off On
On On
Off Off
On Off
Off On
On On
Rack ID - Sets a rack ID for all blades in the rack. Possible ID 0 to 15. The Blade ID, will correspond
to the slot number.
RS-485 Connector - Usually used for connecting Pan Tilt Zoom devices. See page 11 below for pin
assignment information.
I/O Power Connector(s) - 12VDC 100mA out. This connector could be used to supply power to
external units connected to the I/O port.
I/O Terminal Connector(s) - Provides the physical interface for up to 12 I/Os. See page 12 below
for pin assignment information.
Front connectors
Network Activity LEDs 1-4 - 10/100 yellow flashes with activity, 1000M green, flashes with
activity.
PS1 LED - This will indicate a RED light when there is an error in Power supply 1. Please shut down
PS1 and replace with a new power supply. It also indicates if PS1 is disconnected
PS2 LED - This will indicate a RED light when there is an error in Power supply 2. Please shut down
PS2 and replace with a new power supply. It also indicates if PS2 is disconnected
FAN LED - This will indicate if one or more FANS need to be replaced with new ones. Please replace
the fans and reset the fans warning.
NET 3-4 NET1
switch connector
Off Blade 1-4
Off Blade 1-7
Off Blade 1-4
Off Blade 1-10 Do not connect
On Blade 1-4
On Blade 1-7
On Blade 1-4
On Blade 1-14 Do not connect
NET2 NET3
connector connector
Blade 5-7 Blade 8-10
Do not connect Blade 8-10
Blade 5-10 Do not connect
Do not connect
Blade 5-7 Blade 8-14
Do not connect Blade 8-14
Blade 5-14 Do not connect
Do not connect
AXIS Q7900 Installation Guide
NET4
connector
Blade 11-14
Blade 11-14
Blade 11-14
Blade 11-14
Do not connect
Do not connect
Do not connect
Do not connect