Sew Eurodrive MOVIMOT MM D Serie Notice D'utilisation page 14

Correctif
1
Annexes
1.13 Annexes
1.13.1 UL-compliant installation
Field wiring power terminals
Short circuit current rating
Group installation
14
Correctif – MOVIMOT
REMARQUE
En raison des prescriptions UL, le chapitre suivant est toujours en anglais, indépen-
damment de la langue de la présente documentation.
Observe the following notes for UL-compliant installation:
• Use 60/75 °C copper wire only
• Tighten terminals to 1.5 Nm (13.3 in-lb.)
Suitable for use on a circuit capable of delivering not more than 200,000 rms symme-
trical amperes when protected as follows:
For 240V systems:
250V minimum, 25A maximum non-semiconductor fuses or
250V minimum, 25A maximum inverse time circuit breakers
For 500V systems:
500V minimum, 25A maximum, non-semiconductor fuses or
500V minimum, 25A maximum, inverse time circuit breakers
The max. voltage is limited to 500 V.
All models rated 5 kA for group installation when protected as follows:
For 240V systems:
240V minimum, 25A maximum non-semiconductor fuses or
240V minimum, 25A maximum inverse time circuit breaker.
For 500V systems:
500V minimum, 25A maximum, non-semiconductor fuses or
500V minimum, 25A maximum, inverse time circuit breakers.
All models rated 18 kA for group installation when protected as follows:
For 240V systems:
240V minimum, 25A maximum non-semiconductor fuses
For 500 V systems:
500V minimum, 25A maximum, non-semiconductor fuses
®
MM..D