Benelli BN251 Notice D'utilisateur page 86

REAR SHOCK ABSORBER
Spring pre-load adjustment
The rear shock absorber is fitted with an
adjustment ring nut for the pre-load of
spring "A" and a return ring nut "D".
Adjust the spring pre-load as follows:
To increase the spring's preload and
therefore make the suspension more
rigid, turn the adjustment ring nut "A" in
direction (B).
D
C
Senza titolo-2 22
All manuals and user guides at all-guides.com
To reduce the spring's preload and
therefore make the suspension softer,
turn the adjustment ring nut "A" in
direction (C).
At the end of the adjustment, tighten the
return ring nut (D).
A
B
To avoid damaging the mechanism, do
not try turning over the maximum or
minimum setting.
Always
adjusted by a Benelli assistance
centre.
85
IMPORTANT NOTICE:
have the shock absorber
21/12/2015 15:49:53
EN