Benelli BN251 Notice D'utilisateur page 81

EN
MAIN CONTROLS
LEFT DIAL
1) High beam / low beam light
control
Set this switch to "
lights and to " " for low beam lights.
2) Left/right position indicator
switch
Press this switch to enable the left and
right and rear indicators.
Press the centre to disengage them.
3) Sound warning switch
Press this switch to enable the sound
alarm.
4) Passing button
Press this button (daytime) to enable
flashing lights
RIGHT DIAL
1) Electric ignition button
Press this button to start the engine with
the starter device.
Senza titolo-2 17
All manuals and user guides at all-guides.com
2) Emergency light button
With the ignition key set to "
this switch to switch on the emergency
lights (simultaneous flashing of all of the
direction indicators).
The emergency lights are used in case
of emergency, to advise the other road
" for high beam
users that your vehicle is about to stop in
dangerous traffic areas.
WARNING:
Do not use the emergency lights when
the engine is off; this is to stop the
battery from becoming flat.
3) Engine off button
Set this switch to "
on the engine. Set this switch to "
switch off the engine in case of emerge-
cy, such as, for example, when the
motorbike tilts over or the accelerator
cable is blocked.
" use
" before switching
" to
1
80
1
4
2
3
3
2
21/12/2015 15:49:50